Account Configuration
The Root Password screen allows you to set your root password (see Figure 3-17).
Setting up a root account and password is one of the most important steps during your installation. Your root account is similar to the administrator account used on Windows NT machines. The root account is used to install packages, upgrade RPMs and perform most system maintenance. Logging in as root gives you complete control over your system.
Use the root account only for system administration. Create a non-root account for your general use and su - to root when you need to fix something quickly. These basic rules will minimize the chances of a typo or an incorrect command doing damage to your system.
The installation program will prompt you to set a root password[1] for your system. You must enter a root password. The installation program will not let you proceed to the next section without entering a root password.
The root password must be at least six characters long; the password you type is not echoed to the screen. You must enter the password twice; if the two passwords do not match, the installation program will ask you to enter them again.
You should make the root password something you can remember, but not something that is easy for someone else to guess. Your name, your phone number, qwerty, password, root, 123456, and anteater are all examples of bad passwords. Good passwords mix numerals with upper and lower case letters and do not contain dictionary words: Aard387vark or 420BMttNT, for example. Remember that the password is case-sensitive. If you write down your password, keep it in a secure place. However, it is recommended that you do not write down this or any password you create.
 | Note |
|---|---|
Do not use one of the example passwords offered in this manual. Using one of these passwords could be considered a security risk. |
| Note |
|---|---|
The root user (also known as the superuser) has complete access to the entire system; for this reason, logging in as the root user is best done only to perform system maintenance or administration. |
Setting Up User Accounts
If you choose to create a user account now, you will have an account to log in to once the installation has completed. This allows you to safely and easily log into your computer without having to be root to create your user account.
Enter an account name (user name). Then enter and confirm a password
for that user account. Enter the full name of the account user. Once
the information has been entered properly, select the
OK button and press
Once the account has been set up, you will be presented with the User Account Setup screen which will display the account you just entered.
Choose Add to create a new user account.
You can also Edit or Delete the user accounts you have created or no longer want.