Using
Starting opens a single window by which the user may choose appropriate settings and control the formatting process. These options and controls are detailed below.
Make sure that your floppy is not mounted. cannot format a mounted floppy.

Control Settings
The settings are chosen by means of three drop down boxes located at the top left center of .

Floppy Drive
Clicking on the top drop down box, which is labeled Floppy Drivefloppy>, offers the user the following four choices:
3.5" 1.44MB
3.5" 720KB
5.25" 1.2MB
5.25" 360KB
The 800k disk format used by floppy drives cannot be supported on PC floppy drives since they are not capable of formatting disks in that fashion.

File Systems
The third drop down box, labeled File System, offers the user the following two choices:
Dos 	 This selection will have place the MSDOS/ type of file system on the diskette. The user will most likely want to choose this system if she or he will be using the diskette with those operating systems as they do not recognize other system types.
ext2 	 This selection will have place the type of file system on the diskette which is most commonly used with Linux. The user will likely want to choose this system if he or she will only be using the floppy with .

Formatting Options
Within the outline of a box in the left center of the user may find a set of five formatting options. The top two are a pair of radio buttons.
This term (radio buttons) indicates a set of options among which only one can be selected - in the same way that only one preset channel selection may be set on a car radio.
The bottom two options are for labeling the diskette. All are explained below:

Formatting Method
can format a disk in the following two ways:
Quick Format 	 This simply puts the new file system on the disk. All data on the disk is erased. If the density of the disk is different than the selected density, then the tracks and sectors on the disk will be reallocated before the file system is made.
Full Format 	 A full format reallocates the tracks and sectors, puts the selected file system on the disk, and then verifies the format, blocking out any bad sectors it finds.

Verify Integrity
This tells to check that the formatting was correctly written to the floppy. This allows bad sectors to be identified.

Volume Label
The bottom two features allow the user to add (or change) a label to the diskette. If the Volume Label check box is selected then the user can enter a name (label) for the diskette that is to be formatted in the text box located immediately below. When the diskette is subsequently formatted the label will be written to the diskette.

The Buttons
There are three buttons located vertically along the right side of .
Format 	This button initiates the formatting process. Once the user is sure that all the settings are correct he or she may begin the process by clicking on this button. Assuming that a diskette is in place and the parameters are set correctly, the user will see a few changes take place. The label on the button itself will change from Format to Abort indicating that another click on the button will stop the formatting. Furthermore, there will be a change in the two long rectangular boxes that span the bottom of .
The upper box is a status indicator that gives information about the process underway. As the formatting occurs it will contain specific details about the type of formatting. When enters the verification stage of the process this will be displayed.
The lower box is a progress bar. This displays both graphically and numerically the progress of first the formatting and then the verification. Before starting it appears to be empty - showing only the figure 0% in the center. As each process takes place the progress is tracked graphically as the box fills from left to right. At the same time the number in the center will increase reflecting the precise percentage of the process that has been completed.
Make sure that your floppy is not mounted. cannot format a mounted floppy.
Help 	 This invokes the help system starting at the help pages (this document).
Report Bug 	 Report a problem to the team.
About KFloppy 	 This displays version and author information.
About KDE 	 This displays version and author information.
Quit 	 Clicking on this button will close .