Screensaver
Using this module, you can choose your screensaver, determine how quickly the screen is saved, and add or remove password protection to your screensaver.

Choosing the screensaver, and configuring its options
At the top left corner of the module, is a check-box labeled Enable Screensaver. This box must have a mark in it, or will not launch any screensaver and it will not allow you to adjust the settings of your screensaver.
Along the left side, is a list of all available screensavers. You can select a screensaver by simply clicking on the name of the screensaver. Once you have selected a screensaver, you will see a small preview on the preview monitor on the right.
The preview monitor will often show the screensaver larger than it is when the screensaver is activated. This is done on purpose, since many of the details of the screensavers would be uninteligable if actually scaled down to such a small size.
Each screensaver has a different set of setup options. By clicking on Setup, a dialog box will appear with all available options. As you adjust the options, the preview box in the dialog box will show you what effect you will achieve with the current settings.
When you are done setting up your screensaver, click OK.
Clicking Cancel, will erase any changes you made in this dialog box, and return you to the screensaver module.
Clicking About, will give you the Copyright and Author information if you are interested.
When you think you have all the options set the way you want, simply click on Test, to immediately start the screensaver exactly as it will appear.

Setting the time, priority and passwords for screensavers.
Below the Preview Monitor, is a spin box, which determines the period of inactivity before the screensaver should be started. You can enter any number from 1-120 minutes in this box.
Below that, is a check-box, labeled Require Password. If checked, when you click a key, or click a mouse button to end the screensaver, and return to your work, you must enter a password. The password used is the same password you used to login to your machine. If left blank, no password is required.
At the bottom of the right side of the module, is a slider labeled Priority. If your screensaver appears jumpy, you should increase the priority closer to the High end. This will tell your computer to devote more time to the screensaver, and less time to other tasks.

Using a non- screensaver
does not prevent another screensaver from working. To use a different screensaver, such as xscreensaver, simply disable the Screen Saver, and set up your other screen saver program normally.

Removing and restoring a screensaver from your system
If you want to remove a screensaver from the list in this Control Center Module, you will need to rename a file on your system.
Working as a root user is a potentially dangerous situation. While unlikely, it is entirely possible to do permenant damage to your system while working as root.
Be very careful following the next set of directions
To delete a screensaver, type the following commands:

bash$ cd $KDEDIR/share/applnk/System/ScreenSavers
bash$ ls

This will give you a list of files. You will notice similarities between some of the file names and the screensaver you want to remove. Simply rename the file of similarly named desktop file to a name which does not end in desktop.
Example:

bash$ cd $KDEDIR/share/applnk/System/ScreenSavers
bash$ mv KSpace.desktop KSpace.backup

Will remove Space (GL) from the list
You must close the entirely and restart it before the changes will be seen.
To restore the disabled screensaver, simply rename the file back to its original name:

bash$ cd $KDEDIR/share/applnk/System/ScreenSavers
bash$ mv KSpace.backup KSpace.desktop

Restart the , and the screensaver is back in the list.

Section Author
Mike McBride mpmcbride7@yahoo.com