The /etc/XF86Config file tells the X server what kind of
monitor,
video card and mouse you have. You must create it to tell the
server what specific hardware you have.
The easiest way to create this file is to run the XF86Setup utility as root. Refer to QuickStart.doc for details about its use.
You'll need info on your hardware:
The recommended way to generate an XF86Config file is to use the
XF86Setup utility. The xf86config text utility is still there
for the (few) cases where XF86Setup can't be used. Also, there is a
sample file installed as /usr/X11R6/lib/X11/XF86Config.eg,
which can be used as a starting point.
For details about the XF86Config file format, refer to the
XF86Config(5) manual page.
Once you've set up a XF86Config file, you can fine tune the video
modes with the xvidtune utility.
If your serial mouse does not work try using kermit or
tip to connect to the mouse serial port and verify that it
does indeed generate characters.
The OpenBSD pms driver provides both ``raw'' and ``cooked''
(translated) modes. ``raw'' mode does not do protocol translation, so
XFree86 would use the PS/2 protocol for talking to the device
in that mode. ``Cooked'' mode is the old BusMouse translation.
The driver runs in ``raw'' mode when using the /dev/psm0
device name.
On OpenBSD 2.2, only standard PS/2 mice are supported by this driver.
On OpenBSD 2.3 and later include there is support for recent PS/2 mice that send more than three bytes at a time (especially intellimouse, or mouseman+ with a "3D" roller).
See README.mouse for general instruction on mouse configuration in XFree86.
XFree86 supports the dynamic loading of drivers for external
input devices using the XInput extension. Currently supported
devices are:
xf86Jstk.so)xf86Wacom.so)xf86Summa.so)xf86Elo.so)To use a specific device, add the line
load "module"
XF86Config, where module is
the name of the .so file corresponding to your device.
You also need to set up a XInput section in XF86Config.
Refer to the XF86Config(5) man page for detailed
configuration instructions.
You can then change the device used to drive the X pointer with the xsetpointer(1) command.
For joystick support, you'll need to enable the joystick device driver in the kernel. See joy(4) for details.
The PEX and XIE extensions are supported as external modules.
If you want to have access to these extensions, add the following
lines to the Module section of XF86Config:
load "pex5.so"
load "xie.so"